» Insurance
Progressive Insurance
» Sponsors
SportbikeTrackGearMetalArtsProCharger.comSpringfield ArmoryArnottAirRideKomodoGear.comExtreme Custom EngravingAdvanstarMotorcycleShowsMotorcycle.comStoneyStraps.comCycleGear.comTech N' Cycle Gear

» Sponsors
Go Back   V-Twin Forum : Harley Davidson Motorcycle Forums

Please Visit our Site Sponsors Page

View Single Post
Old 01-24-2008, 01:20 PM   #5 (permalink)
RidingJerry
Obsolete Rider
 
RidingJerry's Avatar
 
Join Date: Jun 2005
Location: NC
Posts: 1,656
RidingJerry is on a distinguished road
Since it is a basket case try for $750 to $800.
Yes, I'd but it if I wanted a winter project.
Parts are available as noted above.
You'll plan on tearing down the top end. You'll need new valves and guides
for unleaded gas. Plan on having to bore the cyl. to get them round again.
Replace the clutch pack and the spring. The generator will likely need brushes.
You could even have to replace the rotor. Replace the voltage regulator.
Tires and tubes are a must.
Also, you'll need to replace the front disk brake. The oems rusted out and
are hard to find. Get a PM front and be done with it.

Good luck.
__________________
1998 Obsolete EVO Springer
Now boasting 85 cu in (well, almost)
RidingJerry is offline   Reply With Quote
 
Powered by vBadvanced CMPS v3.0 RC2

Motorcycle News, Videos and Reviews
Harley Davidson Suzuki GSXR Honda 600RR Yamaha R6
Sportbike Forums GSXR Forum Honda 1000RR Yamaha R1
Sportbikes Forum Ducati Forum Kawasaki ZX R6 Forum
Motorcycle Forum Ducati Monster Kawasaki Forum R1 MessageNet

(C)2001- V-twinForum.com All Rights Reserved