Quote:
|
Originally Posted by Snaps
I ordered one today for my '07 FLHX with basic Stage I.
I had great results putting their EFI package with the non-autotune ThunderMax ECM on my '04 Wide Glide with Jim's 120", so I'm really looking forward to this.
Their tech support and response time to all my questions has been great. And I can ask some pretty goofy questions.
I'll report once I get it up and running, hopefully early next week. If it works as well as I hope, and I can figure out how to get bungs welded in my existing pipes on my Wide Glide, I'll eventually switch to the AutoTune on that, too.
|
Welding the bungs in isn't to bad . They have to be within 6 inches of the head. I just got a magic marker and put a dot on the pipe were i wanted the o2 sensor. Then used a unibit to drill it out for the bung. Then i went to a weld shop and had it tig welded. Cost about 40.00 for the weld job and about 10 min. Make sure you leave the plug in when it's welded ,then before you leave the weld shop remove the plug. Somtimes it gets stuck from being welded and then you have heat it with a torch to get it out. Also before you screw your sensor in run a tap in it to clean it up. I think it's 1.5x18 mm. Email me if you need the size and i'll double check it for you.
